Bluetooth: btlinux: adapt to dynamic HCI interface index

Signed-off-by: hmz007 <hmz007@gmail.com>

packages/modules/Bluetooth/system/vendor_libs/linux/interface/bluetooth_hci.cc

@@ -84,10 +84,14 @@ int BluetoothHci::openBtHci() {
   }
   bt_soc_fd_ = fd;
 
-  if (waitHciDev(hci_interface)) {
+  int ret = waitHciDev(hci_interface);
+  if (ret < 0) {
     ALOGE( "HCI interface (%d) not found", hci_interface);
     ::close(fd);
     return -1;
+  } else if (hci_interface != ret) {
+    hci_interface = ret;
+    ALOGD( "HCI interface (%d) found", hci_interface);
   }
   struct sockaddr_hci addr;
   memset(&addr, 0, sizeof(addr));
@@ -173,7 +177,10 @@ int BluetoothHci::waitHciDev(int hci_interface) {
         break;
       }
 
-      if (ev.opcode == MGMT_EV_INDEX_ADDED && ev.index == hci_interface) {
+      if (ev.opcode == MGMT_EV_INDEX_ADDED) {
+        if (hci_interface != ev.index) {
+          ret = ev.index;
+        }
         goto end;
       } else if (ev.opcode == MGMT_EV_COMMAND_COMP) {
         struct mgmt_event_read_index* cc;
@@ -186,6 +193,10 @@ int BluetoothHci::waitHciDev(int hci_interface) {
         for (i = 0; i < cc->num_intf; i++) {
           if (cc->index[i] == hci_interface) goto end;
         }
+        if (cc->num_intf > 0) {
+          ret = cc->index[0];
+          goto end;
+        }
       }
     }
   }

packages/modules/Bluetooth/system/vendor_libs/linux/interface/h4_protocol.cc

@@ -40,6 +40,11 @@ H4Protocol::H4Protocol(int fd, PacketReadCallback event_cb,
       disconnect_cb_(std::move(disconnect_cb)) {}
 
 size_t H4Protocol::Send(uint8_t type, const uint8_t* data, size_t length) {
+    if (disconnected_) {
+      ALOGE("%s error writing to disconnected device", __func__);
+      return 0;
+    }
+
     /* For HCI communication over USB dongle, multiple write results in
      * response timeout as driver expect type + data at once to process
      * the command, so using "writev"(for atomicity) here.
@@ -126,6 +131,11 @@ void H4Protocol::OnDataReady(int fd) {
   }
   if (bytes_read < 0) {
     ALOGW("error reading from UART (%s)", strerror(errno));
+    if (errno == EPIPE) {
+      disconnected_ = true;
+      disconnect_cb_();
+      // LOG_ALWAYS_FATAL("HCI device disconnected");
+    }
     return;
   }
   send_data_to_packetizer(buffer, bytes_read);